Q: What kind of LED is used in PD36R ACE?
A: A LuminusSFT70 Gen2 LED with a lifespan of 50,000 hours.
Q: What is the color temperature of PD36R ACE?
A: Around 6500K.
Q: What is the working voltage of PD36R ACE?
A: The working voltage is 2.8V～4.2V.
Q: Is PD36R ACE rechargeable? How long is the charging time?
A: Yes, PD36R ACE is rechargeable with a hidden USB Type-C port. The indicator will display red while charging and will turn green when fully charged. The normal charging time of the included battery is about 3 hours from depleted to fully charged.
Q: Why does the PD36R ACE downshift to a lower mode after being used for a while and the higher mode cannot be selected?
A: There are two reasons:
1. Intelligent Overheat Protection
The flashlight will accumulate a lot of heat when used at high output levels for extended periods. When the light reaches a temperature of 60°C or above, the light will automatically step down a few lumens to reduce the temperature.
2. Low-voltage Warning
When the voltage level drops below the preset level, the flashlight is programmed to downshift to a lower brightness level until the lowest output is reached.
Q: Why does the PD36R ACE sometimes flicker?
A: The reasons that may cause the light to flicker, shine intermittently or even fail to illuminate:
1. Poor battery level.
Solution: Recharge or replace the battery.
2. The contact or contact point of the battery or flashlight is dirty.
Solution: Clean the contact points with a cotton swab soaked in rubbing alcohol.
If the above methods don't work, please contact your authorized distributor.
Q: What are the optional accessories for PD36R ACE?
A: The PD36R ACE flashlight package comes with a lanyard and a holster. Other compatible accessories include:
- AER-02 V2.0 Remote pressure switch
- ALG-00 Flashlight ring
- ALG-15 Rail mount
- ALG-16 Rail mount
- AOT-S+ Traffic wand
- AOS-F+V2.0 Filter adapter
- AOD-S V2.0 Diffuser tip.
Q: How to operate the SET mode of PD36R ACE?
A: The SET mode features 3 lighting options, which can be selected based on various application scenarios and users’ usage habits. The operations are as follows:
- Loosen the light neck to reveal the hidden SET switch.
- With the light turned on, single click the SET switch to cycle through Option 1(1 output)→Option 2(3 outputs)→Option 3(5 outputs). When users turn on the flashlight for the first time, Option 3 will be selected by default.
- When a lighting option is selected, its corresponding indicator will display green for 3 seconds to confirm the selection. The corresponding numbers indicate the currently available output amounts for each option.
