Q: What kind of LEDs are used in CL20R Pro?
A: Utilizes twenty-seven 2835 LEDs and twenty-four high-quality 2020 RGB LEDs, with a lifespan of 50,000 hours each.
Q: What is the color temperature of CL20R Pro?
A: 3700 - 4200K.
Q: What are the working voltage and the working current of CL20R Pro?
A: Working voltage: 3.0 V - 4.2 V. Max working current: 0.93 A.
Q: Is CL20R Pro rechargeable? How long is the charging time? If the anti-dust cover falls off, will the CL20R Pro remain waterproof?
A: Yes, the CL20R Pro is rechargeable via its USB Type-C port. With the lantern turned off, the normal charging time is approximately 2.5 hours from depleted to fully charged with a 5V/1A or above charging adapter. Once charging is completed, be sure to unplug the charging cable and close the anti-dust cover to prevent the ingress of dust and debris. Its USB Type-C port features an inner waterproof design; therefore, the CL20R Pro will remain waterproof even if the anti-dust cover falls off.
Q: What kind of battery can be used in CL20R Pro?
A: It is recommended to use a Fenix ARB-LP1900 battery. The CL20R Pro is also compatible with three AAA batteries. Other batteries are not recommended, as an unmatched battery may cause the lantern to fail to work normally. Do not mix old and new AAA batteries, as this may damage the lantern.
Q: What is the sensing range of the CL20R Pro's Smart sensing function?
A: The built-in radar module has a wide sensing angle of 90° and can detect movement within a diameter of up to 1.5 meters. For optimal performance, it is recommended to position the camping lantern so that its front or top is facing the area you want to monitor. The lantern will automatically turn on when it detects human movement and will turn off after 60 seconds of no detected motion.
*Turn off the lantern or disable the Smart sensing function when the Smart sensing function is not in use to conserve battery power.
Q: Why does the CL20R Pro downshift to a lower mode after being used for a while and the higher mode cannot be selected?
A: There are two reasons:Â
1. Intelligent Overheat Protection
The lantern will accumulate a lot of heat when used for extended periods. When the lantern reaches a temperature of 50°C/122°F or above, it will automatically step down a few lumens to reduce the temperature. When the temperature drops below 50°C/122°F, the lantern will gradually recall the preset output level.
2. Low-voltage Warning
When the voltage level drops below the preset level, the switch light ring blinks red 6 times every 1 second to remind users to recharge or replace the battery in a timely manner. To ensure normal use, the lantern will not turn off automatically and will work till the battery runs out.
Q: Why might the CL20R Pro flicker?
A: The reasons that may cause the lantern to flicker, shine intermittently or even fail to illuminate:
1. Poor battery level.
Solution: Recharge or replace the battery.
2. The contact or contact point of the battery or lantern is dirty. Â
Solution: Clean the contact points with a cotton swab soaked in rubbing alcohol.
If the above methods don't work, please contact your authorized distributor.
